FILL TIMBER SECTIONS WITH AN 'X'

Co se opravdu už jinam nevejde...
JesseVoss
 
Příspěvky: 13
Registrován: úte 08. kvě 2018 12:51:48

FILL TIMBER SECTIONS WITH AN 'X'

sob 12. kvě 2018 8:48:20

Hi,

The convention, in South Africa at least (not too sure about the rest of the world), for showing new timber in section is with a cross from corner to corner, but I have to touch up "by hand" all my purlins, rafters, wall plates, etc, etc, etc in section and it can be a bit tedious. I thought I might be able to create a new fill that could stretch to fill the cut surface rather than tile, but that doesn't seem to be possible.Any suggestions?

Please help.

I didn't find the right solution from the Internet.

References:-
https://archicad-talk.graphisoft.com/vi ... hp?t=36234
Animated Explainer Video Company

Thanks!

Zpět na Pokec

Uživatelé procházející toto fórum: Žádní registrovaní uživatelé a 1 návštěvník